Remote-technologies IR-PRO T3 User Manual

IR-PROProfessional Infrared Code Capture SystemT3Universal System ControllerT3 Operation Guide v1.0

3 Chapter 2. Introduction FEATURES The T3 provides superior quality and reliability as well as these specific features:  A replacement for all of

T3 Universal System Controller 4  Both infrared (IR) and radio frequency (RF) output options. You can even use both options on the same unit. 

Introduction 5 Do not disassemble the unit. Service of the T3 should be performed by authorized personnel only. CLEANING Occasional cleaning may

T3 Universal System Controller 6 often. Since the T3 can safely be charged after each use, a docking station is included for convenience. If left out

Introduction 7GETTING STARTED Start by inserting the battery connector into the mating plug on the T3. Make sure the connector is oriented properly

T3 Universal System Controller 8 REMOTE REFERENCE Front Touchscreen Display Home Page Button Keypad Buttons Light Sensor Pa

Introduction 9 Back Docking Station Contacts Lithium-ion Battery Pack Power Switch USB Programming Port Audio Speaker IR Transmission Window

T3 Universal System Controller 10 DOCKING STATION REFERENCE Back Front Charge Contacts Charge LED Power Jack Wire Guide Wall Mount Holes 1-3/8 in.

11 Chapter 3. Operation THE TOUCHSCREEN DISPLAY The T3 touchscreen display is organized into a series of pages. Normally each page contains object

T3 Universal System Controller 12 THE CONTROL PANEL PAGE The Control Panel page can be displayed by first setting the T3 power switch to the off pos

iFEDERAL COMMUNICATIONS COMMISSION NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

Operation 13 BACKLIGHT LEVEL This button displays a window that allows you to adjust the backlight brightness and enable/disable the Ambient Light Se

T3 Universal System Controller 14 If the light sensor is enabled, there are two backlight levels to adjust. Press the left arrow or right arrow butto

Operation 15 TIME OUT This button displays a window that allows you to adjust the amount of time the unit stays awake after the last button press. Th

T3 Universal System Controller 16 TILT SWITCH This button displays a window that allows you to adjust the settings for the built-in tilt sensor. The

Operation 17 BATTERY This button displays a window that allows you to adjust the relative amount of time that the low battery icon appears on the dis

T3 Universal System Controller 18 SOUND This button displays a window that allows you to adjust the volume of the audible speaker. The speaker sound

Operation 19 CALIBRATE TOUCHSCREEN This button runs a routine that allows you to calibrate the touchscreen. Since it normally should not be necessary

T3 Universal System Controller 20 PROGRAMMING THE T3 The T3 is programmed using RTI’s TheaterTouch Designer software. RTI dealers can download the s

21 Chapter 4. Troubleshooting If you are having problems with your T3, please read these troubleshooting tips before contacting technical support. I

T3 Universal System Controller 22 IR CODE PROBLEMS If you are using an IR repeater system, make sure it is working correctly with the original OEM re

T3 Universal System Controller ii BATTERY DISPOSAL For environmental reasons, your T3 universal system controller uses “environmentally sound” Lith

23 Chapter 5. Service and Support UPDATES AND NEW PRODUCTS For news about the latest updates, new product information and accessories, please visit

T3 Universal System Controller 24 If you are having a problem with hardware, please note the equipment in your system, a description of the problem,

25 Specifications Power 3.6 VDC, 1300 mAH Li-Ion Battery Pack Power Management Automatic On/Off (tilt switch) Infrared Control Range 30 Fee

T3 Universal System Controller 26 Battery Charge Time 3-4 Hours Total System Memory 32MByt

IR-PROProfessional Infrared Code Capture SystemRemote Technologies Incorporated7651 Anagram DriveEden Prairie, MN 55344Tel: 952-253-3100Fax: 952-253-

iiiServicing. Do not attempt any service beyond that described in the operating guide. Refer all other service needs to qualified service personnel.

T3 Universal System Controller iv Remote Technologies Incorporated is not liable for any damages caused by its products or for its failure of its pro

v Contents Federal Communications Commission Notice ---------------------- i Battery Disposal -------------------------------------------------------

T3 Universal System Controller vi Battery ------------------------------------------------------------------- 17 Sound ------------------------------

1 Chapter 1. Welcome Thank you for purchasing the T3 universal system controller. The T3 combines the power and flexibility of a graphic LCD touchscr

T3 Universal System Controller 2 UNPACKING AND INSPECTION After unpacking your new T3 universal system controller, save all of the packing materials